2 litre HdiI

Discussion in 'General Motoring' started by Creekworm, Nov 25, 2003.

  1. Creekworm

    Creekworm Guest

    Has anyone cracked the knotty problem of the disappearing clips that nold the
    top cover onto the engine. Everyone I know who have cars with this engine have
    lost all four in the first week or so. Also why does the dip stick always climb
    out of it's tube? mine pops out and vibrates violently at tick over and I am
    sure it will eventually fatigue and break off.

    B
     
    Creekworm, Nov 25, 2003
    #1
  2. Creekworm

    Nigel Guest

    Yes it will break eventually! It is caused by the engine cover being
    lose. Either the clips have come off, usually caused by not being put
    on properly, or the rubber mountings under the cover break off.
    A loose cover can also cause the oil filler cao to come off, and I
    have had one case of the water bleed on top of the thermostat housing
    breaking off because the cover was bouncing about on to it.
    So check the clips frequently and renew them if they get lost. Always
    make sure they are fitted correctly too. They should click on. And
    then pull up the cover at each clip point to ensure they will stay on.
     
    Nigel, Nov 25, 2003
    #2
  3. Creekworm

    G.T Guest

    Hello,
    have
    Yes, my parents bought in May a used 206 HDi 90HP, with a missing clip (car
    was 12,000km old), replaced free of charge (took under warranty). I guess
    such clips musn't be expensive at Pug's or at Citroën's. BTW, these clips
     
    G.T, Nov 26, 2003
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.