406 Hdi Warm Starting

Discussion in 'Peugeot 406' started by turboaceman, Sep 17, 2007.

  1. turboaceman

    turboaceman Guest

    I have a 1999 406 Hdi 110. Great car, fully serviced etc. However in
    May this year it failed to start from cold. The engine turned but
    would not fire up. After a succession of trips to a couple of garages
    the pump in the fuel tank was replaced (twice), the engine mounted
    pump and the air flow mass controller was swapped temporarily. The
    glow plugs are OK. Following this the car always starts but often
    after several attempts. It seems that starting a cold engine is not a
    problem, but starting an engine which was hot and then allowed to cool
    for 20 minutes is a problem. Starting a hot engine is OK.

    Has anyone any suggestions where to look next?

    Thanks
     
    turboaceman, Sep 17, 2007
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Heater is luke warm on 306

  2. 405 heater not very warm

  3. 504 Coupe loses power when warm

  4. Warm Starting Problems With A Diesel!

  5. Luck warm heater

  6. 205 problem when warm

  7. Hesitating warm starts `306

Loading...