tyre pressure sensors

Discussion in 'General Motoring' started by %%stu%%, Oct 29, 2007.

  1. %%stu%%

    %%stu%% Guest

    Hi Everyone

    I've got a 407 with pressure sensors on the tyres. I had a tyre replaced
    recently at a tyre dealer , and now the dashboard display comes up after a
    few minutes running saying 'the tyre pressure(s) are not monitored. '

    Talking to a parts dept they tell me the new sensor is £56 + vat to buy and
    I presume there will be a fitting charge. So I'm looking at a £100 bill I
    expect.

    Anyone else had experience of this? Any advice?
     
    %%stu%%, Oct 29, 2007
    #1
  2. %%stu%%

    malc Guest

    Simple question, is the sensor plugged in? Presumably there is a wire
    running to the axle and then some sort of capacative or inductive
    coupling to the sensor in the wheel [1]. So did thetyre fitter
    inadvertantly disconnect the wire. It would only take a few minutes to
    pop the wheel off and check.

    [1] The only tyre sensor I have any knowledge of is on the Airbus A330
    and that was in 1989
     
    malc, Oct 30, 2007
    #2
  3. The sensor was ripped off by an incompetent tyre fitter when they
    changed the tyre.

    You have four choices:

    1/ Ignore the warning.
    2/ Have the dealer reprogram the car so the warning isn't given.
    3/ Get the tyre fitters company to pay for a new sensor to be fitted.
    4/ Pay for it yourself.


    As I bought my Citroen (same system as Peugeot I believe) second hand
    with tyre sensors ripped off by an incompetent tyre fitter I opted for
    2.
     
    Mick Whittingham, Oct 30, 2007
    #3
  4. %%stu%%

    %%stu%% Guest

    Simple question, is the sensor plugged in? Presumably there is a wire
    running to the axle and then some sort of capacative or inductive
    coupling to the sensor in the wheel [1]. So did thetyre fitter
    inadvertantly disconnect the wire. It would only take a few minutes to
    pop the wheel off and check.

    It's a little plastic black box about the size of a swan vestas match box
    inside the tyre connected to the valve.

    Presume it's a little wireless transmitter.

    When the tyre was fitted the company did warn that it was possible the
    sensor would be damaged so I can't argue with them. As they had`fitted 2
    tyres ok a month before I thought they would do the same..
     
    %%stu%%, Oct 30, 2007
    #4
  5. %%stu%%

    %%stu%% Guest

    Just spoken to a Peugeot dealer

    Diagnostic fee then parts purchase and fitting and reprogramming fee. About
    £180 - £200 they reckon. More than the tyre cost!

    Methinks I'll ignore the messages for a while.
     
    %%stu%%, Oct 30, 2007
    #5
  6. %%stu%%

    curious Guest

    was run over by a Dutch artic!
    The nearside rear wheel had to be replaced and
    ever since I got the same message.
    Time passed. I learned to ignore the warning.
    I was suddenly taken ill and was in hospital for
    some time. When I came out I was unable to
    drive for 2 months.
    When I finally got into the car the battery was
    flat so I recharged it, which meant
    disconnecting it.
    In the handbook it says if you disconnect the
    battery you have to wait a few moments after
    first switching on to reset the computer. Since
    then the message has gone away! I still get the
    tyre pressure check telling me "pression ok" so
    maybe it's just a case of rebooting the computer?

    Bob
     
    curious, Oct 30, 2007
    #6
  7. %%stu%%

    %%stu%% Guest

    Intriguing, I'll give it a whirl.

    I wouldn't put it past a dealer to charge £80 to diagnose you need a reboot
    and then £50 to reprogram by disconnecting and rebooting it!
     
    %%stu%%, Oct 30, 2007
    #7
  8. %%stu%%

    malc Guest

    Ok, that's interesting. I wonder where it gets its power from?

    --
    Malc

    Hey there girlie with the torn dress, shaking: who was it touched you?
    Who was it ruined your day?
    Whose footprint calling card? And what they want, stepping on your beach
    anyway?
     
    malc, Oct 30, 2007
    #8
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.